Step |
Action |
Develop |
Use KODAK GBX Developer and Replenisher. |
Attach the film to a film hanger and immerse quickly into the developer solution. Dislodge any air bubbles by tapping the film hanger twice against the tank wall. |
Do not agitate during development. |
Remove the film and hanger 5 seconds before the end of development. |
Do not drain the excess developer back into the developer tank. |
At the end of the development time, immerse the film and hanger rapidly into the stop bath/rinse tank. |
Immerse Film into Stop Bath |
Use KODAK Indicator Stop Bath or running water rinse. |
Temperature: 15.5°C to 29.5°C (60°F to 85°F). |
Time: 30 seconds. |
Agitation: Continuous |
Immerse Film into Fixer Solution |
Use KODAK GBX Fixer and Replenisher or KODAK RP X-OMAT LO Fixer and Replenisher. |
Temperature: 15.5°C to 29.5°C (60°F to 85°F). |
Time: 2 to 4 minutes. |
Agitation: Intermittent (5 seconds every 30 seconds). |
Immerse Film into Wash Tank |
Wash in clean running water (approximately 8 volume changes per hour). |
Temperature: 15.5°C to 29.5°C (60°F to 85°F). |
Time: 5 minutes. |
Dry at room temperature in a dust-free area or suitable drying cabinet. Temperature should not exceed 49°C (120.2 °F). |