Take Pictures Further
Service and Support
Service & Support Main | Ektagraphic Support | Manual Contents |  Previous |  Next

KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual

Tray

Place the loaded slide tray on the projector. Align the tray index bar with the gate index. The tray will drop into position.


Removing the Tray

To remove the slide tray:

  • press the select bar all the way down
  • align the tray index bar with the gate index.



You can then lift off the tray.



Raised Index Mark

This feature allows you to coordinate tray starting positions for multiple-projector presentations. For an 80-slide tray in the zero position, the raised index mark is at slot 20. If you start with slide 6, it will align at slot 26. For a 140-slide tray in the zero position, the index mark is at slot 35. So, if you start with slide 12, it will align at slot 47.





Previous |  Next

Operating Manual Contents

| Important Safety Instructions | Overview | Introduction & Operation/Startup | Slide Tray | Projecting Your Slides | Editing Your Presentations | Clearing a Gate Jam | Using the Built-In Viewer | Using a Disolve Control | Shutdown | Maintenance | Changing the Projection Lamp | Cleaning the Condenser, Heat-Absorbing Glass, and Mirror | Troubleshooting | Warranty | How to Obtain Service | Special-Application Receptacle Identification Chart