KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual

Preparing the Slides

Arrange the slides in the order you wish to show them. Then, one slide at a time:

• Orient the slide the way you want to see it projected. Verify against a light source.
• Rotate the slide 180 degrees - the image will appear upside down.
• Number or mark each mount in the upper right-hand corner.

Inserting the Slides

Remove the lock ring by turning it counterclockwise and lifting it off.

• Position slide tray so that slot 1 is facing right.
• Insert the first slide into first slot in the tray. The number you wrote in the upper right hand corner should be visible on the outer circumference of the tray.
• Insert the rest of your slides in the same manner.

Replace the lock ring by turning it clockwise until it is secure

Rear-Screen
Projection

You can easily adapt a show from front- to rear-screen projection. Remove each slide from the tray and turn it around (keeping the slide upside down). This will give the projected slide a mirror image on the screen.

Insert your first slide back into the first slot in the tray. The number is now visible in the inner circumference of the tray.

Replace the lock ring by turning it clockwise until it is secure.

With a Dissolve
Control

When you use a dissolve control, put your slides into two trays (one for odd- and one for even-numbered slides).

Previous |  Next