Take Pictures Further
Service and Support
Service & Support Main |  Ektagraphic Support |  Manual Contents |  Previous |  Next

KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual

Slide Tray

A KODAK EKTAGRAPHIC Universal Slide Tray is designed to hold up to 80 slides. Be sure that your slide mounts are in good condition; frayed or bent mounts may fail to drop into the projector. A variety of slide trays are available with capacity up to 140 slides. See your dealer in Kodak products for a complete list of Kodak trays and accessories.

NoteNote
Do not attempt to project slides mounted with sticky or loose tape.

Setting the Tray Alignment

Before inserting slides, always make sure the tray is in the correct locked position.

To correctly lock an 80-slide tray:

  • Rotate the bottom plate until it locks at the zero position.
  • Align tray index notch with base plate cutout.

To correctly lock a 140-slide tray:

  • Move the latch release toward the center, then rotate the tray.
  • Rotate the bottom plate until the index hole aligns with the index notch located at slot 1.

80-Slide Tray


140-Slide Tray



Previous |  Next

Operating Manual Contents

| Important Safety Instructions | Overview | Introduction & Operation/Startup | Slide Tray | Projecting Your Slides | Editing Your Presentations | Clearing a Gate Jam | Using the Built-In Viewer | Using a Disolve Control | Shutdown | Maintenance | Changing the Projection Lamp | Cleaning the Condenser, Heat-Absorbing Glass, and Mirror | Troubleshooting | Warranty | How to Obtain Service | Special-Application Receptacle Identification Chart