KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual
Startup
Models A,
AMT and ATS
Open the storage compartment and remove the remote control.
Plug the 5-pin cable remote connector into the remote-control receptacle, aligning the raised dot with the metallic rivet head.
This receptacle also accepts plugs for accessories, such as Kodak dissolve controls.
Plug the power cord into a grounded outlet with 110- to 125-volt 60 Hz current only.
Operating Manual Contents
| Important Safety Instructions | Overview | Introduction & Operation/Startup | Slide Tray | Projecting Your Slides | Editing Your Presentations | Clearing a Gate Jam | Using the Built-In Viewer | Using a Disolve Control | Shutdown | Maintenance | Changing the Projection Lamp | Cleaning the Condenser, Heat-Absorbing Glass, and Mirror | Troubleshooting | Warranty | How to Obtain Service | Special-Application Receptacle Identification Chart