KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual
Cleaning the Condenser, Heat-Absorbing Glass, and Mirror
To clean the condenser, heat-absorbing glass, or mirror, you must disassemble the lamp module.
Slide the power switch to Off and unplug the projector. Allow the projector to cool about 10 minutes. Push the lamp-module release button and remove the lamp module.
Use a torx-head screwdriver to remove the screw.
Using a flat-blade screwdriver, apply ample pressure to release each of the metal tabs.
Lift off the top of the lamp module.
Operating Manual Contents
| Important Safety Instructions | Overview | Introduction & Operation/Startup | Slide Tray | Projecting Your Slides | Editing Your Presentations | Clearing a Gate Jam | Using the Built-In Viewer | Using a Disolve Control | Shutdown | Maintenance | Changing the Projection Lamp | Cleaning the Condenser, Heat-Absorbing Glass, and Mirror | Troubleshooting | Warranty | How to Obtain Service | Special-Application Receptacle Identification Chart