KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual
Maintenance
To ensure a long life and trouble-free operation for your projector:
- Allow the air to flow freely around the projector.
- Do not recirculate warm air.
- Keep the projector dust free.
- If your projector is chilled, bring it to room temperature before operating.
Projection Lamps
Quartz-halogen 82 V projection lamps--
Included: EXR, 300 W (35-hour lamp life at full lamp/medium-brightness)
Sampling of other lamps:
- EXY (200 hours/less brightness)
- EXW (15 hours/maximum brightness)
- FHS (70 hours/medium brightness)
Use combinations of lamp brightness, plus half- and full-lamp settings to approximate image brightness in multi-projector presentations.
|
Desired
Brightness |
EKTAGRPAHIC III
Projector Lamp |
|---|---|
| Maximum | EXW |
| High | EXR |
| Medium | FHS |
| Low | EXY |
Lamp Tips
- Projector operation on line voltages above 125 volts greatly reduces the lamp life.
- Unplug the projector before changing the lamp.
- Allow for unrestricted flow of air to the exhaust vent to prolong lamp life.
- Gently wipe off any fingerprints with a soft cloth moistened with rubbing alcohol.
Operating Manual Contents
| Important Safety Instructions | Overview | Introduction & Operation/Startup | Slide Tray | Projecting Your Slides | Editing Your Presentations | Clearing a Gate Jam | Using the Built-In Viewer | Using a Disolve Control | Shutdown | Maintenance | Changing the Projection Lamp | Cleaning the Condenser, Heat-Absorbing Glass, and Mirror | Troubleshooting | Warranty | How to Obtain Service | Special-Application Receptacle Identification Chart