Take Pictures Further
Service and Support
Service & Support Main | Ektagraphic Support | Manual Contents |  Previous |  Next

KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual

Screen Image

Use the elevating foot to horizontally center the projected image on the screen. To release the foot, press the release button, while lifting the front of the projector to the desired height. Use the elevating wheel to make fine adjustments.

If the image is not level, make an adjustment by turning the leveling foot at the rear of the projector.

Timer
(Models AMT & ATS only)

To time your slides, use the timer switch for slide changes from 3 to 22 seconds.


To interrupt the timer, press either the forward or reverse button. For manual operation, slide the timer switch to Off.




Previous |  Next

Operating Manual Contents

| Important Safety Instructions | Overview | Introduction & Operation/Startup | Slide Tray | Projecting Your Slides | Editing Your Presentations | Clearing a Gate Jam | Using the Built-In Viewer | Using a Disolve Control | Shutdown | Maintenance | Changing the Projection Lamp | Cleaning the Condenser, Heat-Absorbing Glass, and Mirror | Troubleshooting | Warranty | How to Obtain Service | Special-Application Receptacle Identification Chart