Take Pictures Further
Service and Support
Service & Support Main | Ektagraphic Support | Manual Contents |  Previous |  Next

KODAK EKTAGRAPHIC III Slide Projectors
Operating Manual

Projecting Your Slides

Lens

To insert a lens, push the focus knob up and position the lens gear teeth on the lens barrel with the notch on the projector.

Lamp

Slide the power switch to half lamp (for longer lamp life) or lamp (for maximum brightness).

You may want to keep a spare KODAK EC Lamp Module (CAT 831 3587) handy in case the lamp burns out during a presentation. Replacing the entire module makes the change quick and easy. (See Maintenance for instructions on changing the lamp module.) See your dealer in Kodak products to order this module.


Previous |  Next

Operating Manual Contents

| Important Safety Instructions | Overview | Introduction & Operation/Startup | Slide Tray | Projecting Your Slides | Editing Your Presentations | Clearing a Gate Jam | Using the Built-In Viewer | Using a Disolve Control | Shutdown | Maintenance | Changing the Projection Lamp | Cleaning the Condenser, Heat-Absorbing Glass, and Mirror | Troubleshooting | Warranty | How to Obtain Service | Special-Application Receptacle Identification Chart