|
|
 |
|
|
|
|
Changing the Paper Print Width
|
|
|
| |
Kodak Professional RP 50 LED Printer
Kodak Professional LED II Printer 20P
Kodak Professional LED II Printer 20R
4 October 2002
General Information
Page start values vary slightly for all three sizes of paper.
To modify the print width, make a full-length print without the
76 pixel overspill on the paper width that you want to modify, then
follow the instructions to calculate the new width.
Instructions
| Step 1: |
Measure the amount of non-image white
space on the edge of the full-length print.
|
| Step 2: |
Convert the above amount into a pixel value at 250 dpi
(dots per inch).
Example A: 1/8" = .125" x
250 dpi = 32 pixels (rounded up)
Example B: 1/4" = .250" x
250 dpi = 63 pixels
Example C: 3/16" = .1875" x
250 dpi = 47 pixels
This is the numerical value applied to the existing page start
number to center the image on the page.
Important: Note which side of the print
is the front (the OCP - Operator Control Panel) and which is the
back. You will need this information for Step 9. If the white space
is on the front of the print, you must add it to the existing page
start. If the white space is on the back of the print, you must
subtract the number from the current page start.
Example: From the OPC on-line ready, press the
On/Offline key
to take the printer to offline-idle mode.
|
| Step 3: |
Press
Menu. The main menu appears.
|
| Step 4: |
Use the keyboard arrow keys to navigate to the Printer.
|
| Step 5: |
Press
Start.
|
| Step 6: |
Go to
Page Starts. A page start
number is listed for all three paper widths.
|
| Step 7: |
Use the keyboard arrow keys to select the paper width you
want to modify.
|
| Step 8: |
Press
Start to highlight the first
number slot in the page start value.
|
| Step 9: |
Either add or subtract the calculated pixel value (See
Step 2).
|
| Step 10: |
Use the keyboard arrow keys to navigate to the next number
slot.
|
| Step 11: |
Use the keyboard arrow keys to change the number value
in that slot to the desired value.
|
| Step 12: |
Press
Start to exit the number
edit mode.
|
| Step 13: |
Use the keyboard arrow keys to return to
Exit.
|
| Step 14: |
Return to the main screen. When you go back online, the
OCP indicates it is resetting.
|
| Step 15: |
Go to
Online-Ready.
|
You are now ready to start printing again with the adjusted width.
Example:
PPM1 page start values: starting: 47 modified: 15
 Kodak and Kodak Professional are trademarks of Eastman
Kodak Company.
TIB7035Technical Information Bulletins provide information of limited or specific application. Responsibility for judging the applicability
of the information for a specific use rests with the end user.
|
|
