|
An RS-232 serial cable is provided so you can connect your camera to a Windows-based computer.
|
|
-
Set the Mode dial to Connect.
-
Plug the appropriate end of the serial cable into an available 9-pin serial port on the computer.
Serial ports are usually labeled COM1 and COM2, or A and B. If your computer has a 25-pin port, you need to use a 9-pin adapter (available at your local computer store) and attach it to the port before attaching the serial cable to the computer.
If the ports are not labeled, see your computer User's Guide for a diagram that illustrates all of the external ports.
-
Open the serial/USB port door on the side of the camera.
-
Plug the other end of the serial cable into the camera serial port.
-
Slide the POWER switch to the right to turn on the camera.
If you get a message on your computer stating that you are not connected, refer to the Serial.PDF document installed with the software, or the online help for troubleshooting information.
|
Previous |
Next
Main Table of Contents
Connecting Your Camera:
Using Serial Cable Connection
|
Connecting to Windows Computer
|
Connecting to Macintosh Computer
|
Using USB Cable Connection
|
Starting Software for Windows
|
Starting Software-Macintosh
|
Navigating to Pictures
|
