Service & Support Main | DC40 Support | Owner's Manual Contents

KODAK DIGITAL SCIENCE DC40 Camera
Installing the Batteries

Four lithium batteries come with your DC40 Camera, however, you can also use rechargeable NiCad or AA alkaline batteries. This section describes how to install the batteries. Refer to Using Batteries, for more information about battery use.

Warning
Mixing battery types in the camera may cause a fire or explosion. Install only batteries of the same type at one time.

1. Push firmly on the battery compartment cover in the direction of the arrow. The cover will slide along its track until it can be removed. An illustration at the bottom of the battery compartment indicates the position for the top and bottom pairs of batteries.

   

2. Adjust the battery removal ribbon so that it rests on the bottom of the battery compartment.
3. Insert the bottom pair of batteries with the positive ends (the ends with a bump) toward the front of the camera.

   As you are installing each battery, first insert the negative (flat) end into the recessed area toward the back of the camera, and then push the positive end into place.

   Note: The batteries fit snugly.

   

4. Insert the top pair of batteries with the positive ends (the ends with a bump) toward the back of the camera.

   As you are installing each battery, first push the negative (flat) end against the metal tab toward the front of the camera, and then push the positive end into place.

5. Place the battery compartment cover into its track and then slide it back until it clicks into place.

Owner's Manual Contents
Features | Getting Started | Installing Batteries | Camera On and Off | Using the Camera | Using Batteries | Using Power Adapter | Connecting to a Computer | Maintenance | Troubleshooting | Specifications | Regulatory Information