Service & Support Main | DC290 Support | Owner's Manual Contents
KODAK DC290 Zoom Digital Camera
User's Guide
Installing the Batteries
WARNING
Do not mix different types of batteries in the camera.
- Open the battery door.
- Slide the inside battery cover toward the back of the camera and then lift it away from the camera
- Insert the batteries as indicated on the battery cover.
- Close and lock the inside battery cover and battery door.
Remove the batteries if the camera will not be used for an extended period of time. This will extend the battery life and prevent camera damage from battery leaks or corrosion. If the batteries are removed from the camera for more than a few days, the date and time will be deleted and must be reset.
When using batteries, limit the continuous operation of the color LCD for previewing pictures to less than 20 minutes. This is particularly true with Lithium batteries. Previewing pictures requires a significant electrical current, which over time could cause your batteries to heat up significantly. Should your camera become too hot inside, it is designed with protective circuitry to turn itself off. You should allow sufficient time for the camera to cool before turning it on again. Consider using an AC Adapter for KODAK DC200 Series Digital Cameras when using Preview mode for extended periods. Always follow your battery manufacturer directions fully.
Owner's Manual Contents
Main Table of Contents
Getting Started
Introduction
|
Camera Features
|
Specifications
|
Softkeys
|
Mode Dial and Four-Way Controller
|
Status LCD
|
Installing Batteries
|
Memory Card
|
Power Management