Take Pictures Further
Service and Support
Service & Support Main | DC220 Support | DC260 Support | Owner's Manual Contents

KODAK DIGITAL SCIENCE™ DC220/DC260 Zoom Camera
Entering the Connect mode

To enter the Connect mode:

  1. Set the Mode dial to Connect.

Which connection?

Which connection should you use to transfer pictures between your camera and computer? That depends on which connections your computer supports. The following sections will help you determine the connections that your PC supports.

You specify the type of connection you are using through the Camera Properties software. For information on how to choose a connection method, refer to Setting camera properties.

Operating System Connection Option
WINDOWS 95
WINDOWS 95a 		Serial, IrDA[1]
WINDOWS 95B (also known as OSR2) Serial, IrDA, USB [2]
WINDOWS NT 4.0 Serial
[1] WINDOWS 95 and WINDOWS 95a require an IrDA Software Patch that is available from MICROSOFT's Web site, at www.microsoft.com. (Please read and understand all the instructions provided by MICROSOFT before proceeding.)
[2] WINDOWS 95B requires the MICROSOFT USB Supplement. Contact your PC vendor or manufacturer for the Supplement.
The IrDA driver for WINDOWS 95B is either preloaded on your system or available on your original diskettes or CD-ROM.
To determine which version of WINDOWS 95 is installed on your PC:
  1. Click Start > Settings > Control Panel.
  2. Double-click the System icon.
  3. Double-click the System icon.
4.00.950 indicates WINDOWS 95 (basic)
4.00.950a indicates WINDOWS 95a
4.00.950B indicates WINDOWS 95B

Owner's Manual Contents
Main Table of Contents
Connecting
Introduction | Connect mode | RS-232 Serial | USB | Infrared transceiver | Potential problems