Service & Support Main | DC220 Support | DC260 Support | Owner's Manual Contents

KODAK DIGITAL SCIENCE™ DC220/DC260 Zoom Camera
Marking pictures for an action

When you want to select a number of pictures and carry out an action on them, you must first mark each picture. Marked pictures can be deleted, copied from camera to camera, or moved from album to album (DC260 only).

To mark a picture:

1. Scroll to find the picture you want to select.

   Use any of the three methods described in the Viewing pictures section.

2. Press the MARK softkey.

   The selected picture is marked, denoted by the notched lower right corner. It remains marked until you carry out an action on it.

   Note: To mark the entire contents of the memory card, hold down the MARK softkey for 2 seconds.

   Note: When you have marked a picture, the softkey changes to UNMARK.

Placing marked pictures in an album (DC260 only)

You can place marked pictures in an existing or new album.

1. Press the MENU button.
2. Press the right arrow to highlight the Album icon.
3. Press the down arrow to select an existing album or New Album.

   Refer to the next subsection for information about creating a new album.

4. Press the MOVE softkey.

   The marked pictures are moved to the selected album.

Creating a new album

To create a new album:

1. Display the Album screen as described in the "Placing marked pictures in an album" section above.
2. Press the down arrow to select New Album.
3. Press the MOVE softkey.

   The New Album Name screen appears.

4. Press the left softkey to select the type of character set you want to choose from:
   • capital letters
   • numbers
5. Press the up and down arrows to select a character.
6. Press the right arrow to add the selected character to the name.

   Note: Press the left arrow to backspace.

7. Add additional characters until you have spelled the name you want using a maximum of 8 characters.
8. When you are satisfied with the name, press the DONE softkey.

   The marked pictures are moved to the album you created and the Album screen appears.

Copying marked pictures from camera to camera

You can send marked pictures to or receive marked pictures from another camera in the Review mode:

1. Place the two cameras facing each other aligning their infrared transceivers.

   During Camera to Camera communication, the cameras communicate via infrared port.

2. Make sure both cameras are in the Review mode.
3. Press the MENU button on the receiving camera.
4. Press the down arrow key to highlight RECEIVE.
5. Press the MENU button on the sending camera.
6. Press the down arrow key to highlight SEND.
7. Press the SEND softkey.

   The marked pictures are copied from one camera to the other.

Owner's Manual Contents
Main Table of Contents
Reviewing Pictures
Introduction | Review mode | Viewing pictures | Viewing remaining memory | Marking pictures | Opening albums | Expanding and collapsing | Adding sound | Deleting one picture | Deleting multiple pictures | Sound, bursts, timelapse | Magnifying pictures | Viewing pictures on TV