|


Service & Support Main | DC240 Support | DC280 Support | Owner's Manual Contents
There might be times when you want everyone, including yourself, to be in the picture. For these occasions, use the Self-Timer feature to create a 10-second delay between the time you press the SHUTTER button and the time the picture is taken.

- Set the Mode dial to Capture.
- Slide the POWER switch to the right to turn on the camera.

- Press the SELF-TIMER button.
The Self-timer icon appears in the Status Display.
If you want to the cancel self-timer before the picture is taken, press the SELF-TIMER button again or turn off the camera.
- Place the camera on a flat, steady surface or tripod.
- Frame your subject in the viewfinder and press the SHUTTER button.
The red Self-Timer light, located on the front of the camera, turns on and stays lit for 8 seconds, then flashes for 2 additional seconds just before the picture is taken.
The Self-Timer turns off when the picture is taken.
Owner's Manual Contents
Main Table of Contents
Taking Pictures
Introduction
|
Previewing
|
Shutter Button
|
Zooming
|
Viewing Picture Just Taken
|
Setting a Quickview
|
Flash
|
Distant Subjects
|
Close-Ups
|
Self-Timer
|
Adding Date
|
Deleting Picture Just Taken
|