|


Service & Support Main | DC215 Support | Owner's Manual Contents
There might be times when you want everyone, including yourself, to be in the picture. For these occasions, use the Self-Timer feature to create a 10-second delay between the time you press the Shutter button and the time the picture is taken.
- With the camera on, set the Slider switch to Capture.
- Press the Self-Timer button.

The Self-Timer icon appears in the Status Display.
To cancel the Self-Timer before the picture is taken, press the Self-Timer button again or turn off the camera.
- Place the camera on a flat, steady surface or tripod.
- Frame your subject in the viewfinder and press the Shutter button.
The red Self-Timer light, located on the front of the camera, turns on and stays lit for 8 seconds, then flashes for 2 additional seconds just before the picture is taken.
The Self-Timer turns off when the picture is taken.
Owner's Manual Contents
Main Table of Contents
Taking Pictures
Introduction
|
Previewing
|
Capturing
|
Zooming
|
Close-Ups
|
Self-Timer
|
Viewing & Deleting Picture Just Taken
|
Flash
|
Adjusting Exposure
|
Locking Exposure
|
Deleting Picture Just Taken
|