Firmware / Software downloads

KODAK PROFESSIONAL SRP 30 and RP 30 Laser Printers

KODAK PROFESSIONAL ENDURA papers (PORTRA, SUPRA, ULTRA and METALLIC) can be used in the KODAK PROFESSIONAL RP 30 and SRP 30 Laser Printers. The printers must be running software version 7.60D or later.

The following table contains the recommended starting-point setup values to use with KODAK PROFESSIONAL color papers. The values for DMax and Cal factor should not normally be changed from these recommended values. The "Production Balance - Digital" values can be adjusted, if necessary, to change the color balance or density balance of all output prints from digital files to achieve a preferred color or density bias. Similar balance changes can be made to prints produced from color negative film scans by modifying the "Neutral Exposure" values in the "Color Balance" menu of the "Production Balance - Color Negative" screen. Refer to the Appendix of the RP30 (or SRP 30) Laser Printer Operator's Guide Guide for instructions regarding the proper installation and use of these parameters in the printer software. Those instructions are also reproduced in .pdf documents accessible through these links:

1. Click on any link above to initiate a software download.
2. Save the installer to your hard drive.
3. Double-click on the downloaded file in order to start the installation.
4. Follow the prompts to install the files. Refer to the appropriate documentation for procedures to copy the files to the correct directories on the imaging application host computer.
5. Review the readme file (if any) included with the installer.